Ceramic, Sandstone and Porcelain Wall and Floor Tiling, Newcastle NSW

The Process

How do we do floor and walls tiling and things you need to take care of?

A professional tiler and the right material are all one needs to make or repair an area. There are a few differences when it comes to tiling floor and wall. For example, floor tiles are more robust and less smooth than wall tiles, so approaches to tiling them might be a little different. Here we discuss the general procedure of how the tiling process is carried out.

1. Before starting the job, one needs to check for all the flaws in the surface. The surface needs to be smooth, level and free of any debris. Appliances such as the doorjambs need to be checked for clearance so that the process of the tiling is continuous and uninterrupted.
2. The next step we do is identify the centre points of each wall in the room. Center points on the opposite walls are connected through a chalk line running through the centre of the room. Then a row of loose tiles is laid out from the centre of the room till the walls. Then the tiles are cut according to need; this helps in a better and efficient layout.
3. The next step is applying the adhesive in the right amount and matter. What we do is to take only the amount of glue we would be using in the next 30 mins. This would help in not wasting materials. Then the trowel is held at a 45-degree angle, and the adhesive is spread. The excessive paste is then removed, leaving behind a smooth surface ready to be tiled.
4. Following, we proceed to cut out tiles according to one’s needs. If the cuts are of full-length nature, better to use a rod saw for best results. Tiles need to be marked with a pencil before initiating the process; this way, we reduce errors and improves accuracy. After cuts are done, carborundum stone should be used to provide a smooth finish.
5. Now that all the prerequisite steps have been performed, it is time to place the tiles. The installation is started from the centre of the room and completed one grid at a time. Tiles are then laid out skillfully, leaving spaces between tiles and walls. All laid tiles are then tapped to level. The excessive adhesive should be removed, and the tiles should be allowed to settle down for at least 24 hours.
6. The last and final step of this whole process is grouting. It is the process where all the spaces left between tiles are filled with material. The grout is forced properly down the joints and allowed to settle. Excessive grout is then removed with a damp sponge to smooth the surface.